sandersmetal.com/metal-roofing-trims/stepflash
HomeMetal roofing trimsStep flashing

Step flashing

SSMSTEP
Roofing trim · roof-to-wall
Sanders standard spec
Legs4" × 4"
Bend55° as sold online
Material24 ga Kynar
Sold as10-ft section
Custom order form
OverviewMaterialsSizes & profileInstallationColors
Step flashing installed system render
Step flashing — cut one piece per shingle course, each lapping the one below it up the wall
Ships as a 10-ft section — cut to your course
Each course sheds onto the next
Wall leg tucks under the wrap
Cut to your pitch
24 & 26 gauge steel
29 standard colors
Custom orders quoted by the lineal foot
Fabricated to your drawing
Step Flashing works the roof-to-wall joint one course at a time — each piece laps the one below it down the slope so water always lands on metal. Online it ships as a 10-ft section, 4" × 4" legs at a 55° bend, and you cut it to your course length. On custom orders we set the bend to your pitch and quote by the lineal foot.

Step flashing is fabricated from steel and finished in your choice of standard or custom color with a durable factory paint finish. The substrate carries the mill’s coating; the paint finish carries the coating manufacturer’s warranty. Tell us your color and gauge and we’ll match the job.

Gauge24 / 26 ga
Step flashing — standard profile dimensions

Standard profile shown — online orders are exactly this piece. Need different dimensions? We custom-bend to order — request a quote.

Bend angle55° online — set to your pitch on custom orders
LengthUp to 10′
Miters & splice platesOptional — ask us

Step-by-step install for Step flashing — laps, fastener spacing, sealant, and the transitions where it meets panel, wall, and valley. Open the full guide:

Available in every color on the SSM color chart — 29 standard colors plus custom finishes, color-matched to most manufacturers. Bare galvalume and galvanized are available too.

Want Step flashing on your next roof?

Tell us the leg lengths, gauge, and color — we’ll quote it fast.

Get a free quote